10-27-2016, 08:36 PM
Hi Gintaras,,
I keep getting this message at the startup of my computer:
Error: Quick Macros service is not running. Reinstall Quick Macros.
Warning: Could not run as administrator. QM will not work with some programs.
note: cannot open file to read-write: 'C:\Program Files (x86)\Quick Macros 2\Samples2.qml'.
Using read-only copy: 'C:\Users\GertAdmin\AppData\Local\Temp\QM\LocalCopy\399ffdf3-samples2.qml'
Error: Quick Macros service is not running. Reinstall Quick Macros.
Failed to set process notifications. Process triggers will not work.
I reinstalled several times, and the message disappears but reappears with new restarts.
Stopping and restarting QM, QM sometimes starts OK, without error mess, but often with the same error mess.
Reinstalling and restarting QM starts without error mess.
Restarting the computer (without reinstalling QM) sometimes QM does not produce the error message but often it does.
More testing: After two problem restarts and reinstalls, now I had 7 successive restarts which were without any problems (QM didn't produce any errors at all).
In Services I noticed QM was set to Manual.
In Services Recovery tab I've put in: On services start failure -> Run a program. But nothing runs when QM says 'service not started'
Regards,
GertC
I keep getting this message at the startup of my computer:
Error: Quick Macros service is not running. Reinstall Quick Macros.
Warning: Could not run as administrator. QM will not work with some programs.
note: cannot open file to read-write: 'C:\Program Files (x86)\Quick Macros 2\Samples2.qml'.
Using read-only copy: 'C:\Users\GertAdmin\AppData\Local\Temp\QM\LocalCopy\399ffdf3-samples2.qml'
Error: Quick Macros service is not running. Reinstall Quick Macros.
Failed to set process notifications. Process triggers will not work.
I reinstalled several times, and the message disappears but reappears with new restarts.
Stopping and restarting QM, QM sometimes starts OK, without error mess, but often with the same error mess.
Reinstalling and restarting QM starts without error mess.
Restarting the computer (without reinstalling QM) sometimes QM does not produce the error message but often it does.
More testing: After two problem restarts and reinstalls, now I had 7 successive restarts which were without any problems (QM didn't produce any errors at all).
In Services I noticed QM was set to Manual.
In Services Recovery tab I've put in: On services start failure -> Run a program. But nothing runs when QM says 'service not started'
Regards,
GertC