running "mac" without arguments = endless cycle

[r0n]

I noticed when running a "mac" command without parameters (to be clear: only the "mac" command), results in an endless cycle of: "Warning (RT) in ... Launching macro from". Normally a user would not run it empty (no arguments).
I also tested this in a clean portable version of QM (the state in which QM is, immediately after a clean installation).

[Gintaras]

From mac help:

macro - QM item name (full, case insensitive) or id (integer).
•If omitted or "" - QM item that is currently open in the code editor.

Macro Macro2795

Code:

Copy      Help

mac

;If you run this macro from QM with the Run button, mac will start this macro again when this macro ends. Endless loop.

[r0n]

ai :oops:
Sorry about this, the warning was right there.
Thanks!